Metal Building Contractor in New Mexico
Mountain State Construction is a pre-engineered metal building (PEMB) erector and steel building contractor working across New Mexico, from Albuquerque and Santa Fe to Farmington, Las Cruces and the southeast. We have erected commercial steel buildings up to 100x200 in Albuquerque and Bloomfield, and we engineer every project for its site's wind, soils and elevation.
Steel building erection across New Mexico.
New Mexico is a big state with very different conditions from one region to the next. Here is where we work and what we have built.
Albuquerque & Rio Rancho
Our largest New Mexico build is a 100x200 single-slope commercial warehouse in Albuquerque. We erect warehouses, shops, flex space and commercial buildings across the Albuquerque metro and the Middle Rio Grande valley.
Farmington & the Four Corners
We have erected two commercial steel buildings in Bloomfield, including a 100x200 clear-span building with multiple overhead doors. The San Juan Basin is a short haul from our aircraft hangar projects in Durango, Colorado.
Santa Fe & Los Alamos
Northern New Mexico sits near or above 7,000 feet, where snow and elevation drive the design. We have built a steel barndominium in Santa Fe and size every frame to its own site.
Las Cruces & Southern New Mexico
Low desert, intense sun and summer heat. We erect commercial, agricultural and shop buildings across the southern part of the state, with roof and wall finishes chosen for sun exposure.
Roswell, Hobbs, Carlsbad & Clovis
The eastern plains bring steady wind and open exposure. We erected a 66x150 commercial building in Capitan, and we take on commercial, agricultural, equipment storage and shop projects across southeast New Mexico.
Rural & Ranch Sites
Many New Mexico projects sit well outside town. We erect agricultural buildings, equipment storage and shops on rural and ranch properties across the state.
New Mexico conditions.
New Mexico runs from low southern desert to northern mountains, so conditions swing widely from one site to the next. Wind and sun are constants, the Rio Grande rift raises seismic demand through the center of the state, and caliche and expansive soils make the foundation worth a careful look. We engineer each building to its exact site.
Wind
Strong across the eastern plains and through the spring season. Open terrain pushes exposure up, so we set speed and exposure per site.
Seismic
The Rio Grande rift runs through central New Mexico and raises seismic demand in places. We confirm the seismic design category against the governing code rather than assume it.
Soils
Caliche, expansive clays, and collapsible soils show up across the state. A geotechnical report drives the foundation so it's built for the ground you have.
Sun & Temperature
Intense high-desert sun and wide daily temperature swings factor into material and finish choices so the building holds up over the long run.
Snow & Elevation
Low across the southern desert and real in the northern mountains around Santa Fe and Taos. We size snow load to your site's elevation, not a state figure.
Code & Permitting
New Mexico administers building regulation at the state level, with local requirements layered on in many areas. We deliver stamped drawings built to the authority that governs your site.
New Mexico projects.
Bloomfield, NM
Santa Fe, NM
Bloomfield, NM
Albuquerque, NM
Capitan, NM
Every building type, across New Mexico.
We erect commercial and warehouse buildings, aircraft hangars, agricultural buildings, riding arenas, self storage, steel shops and garages and barndominiums across New Mexico. Start with the building type that fits your project, then bring it into a quote for your site.
Explore Building TypesNew Mexico FAQ.
Which parts of New Mexico do you serve?
All of it. We have built in Albuquerque, Santa Fe, Bloomfield and Capitan, and we take on projects in Rio Rancho, Farmington, Las Cruces, Roswell, Hobbs, Carlsbad, Clovis, Los Alamos and everywhere in between.
What size buildings have you erected in New Mexico?
Our New Mexico projects range from a 45x52 barndominium in Santa Fe to 100x200 commercial buildings in Albuquerque and Bloomfield.
Is seismic a factor in New Mexico?
It can be. The Rio Grande rift raises seismic demand through the center of the state, so we confirm the seismic design category for your site against the governing code.
My site has caliche or expansive soil. Can you handle it?
Yes. We start from a geotechnical report and design a foundation built for that ground rather than assuming it.
Will you provide drawings for the permit?
Yes. We deliver engineered, stamped drawings built to the state and local authority that governs your site.
More areas we serve.
Colorado
More than 40 projects across four Colorado regions.
Explore ColoradoArizona
Low desert to the Flagstaff high country, built for heat and monsoon wind.
Explore ArizonaUtah
The Wasatch Front and beyond, where heavy snow meets real seismic ground.
Explore UtahWyoming
High plains and mountain valleys, where wind drives the engineering.
Explore WyomingBuilding in New Mexico?
Tell us your site and what you're putting up, and we'll prepare an engineered quote built to your local conditions.